Metacem

Permanent dual cure resin cement

Metacem is an adhesive resin cement with high strength properties for a great permanent seal. This dual cure cement can be used on crowns and bridges (made of ceramic, composite, or porcelain), inlays, and onlays. Metacem is also ideal for bonding porcelain veneers and cementing endodontic posts. It has high resistance to compressive force, and comes in 5 VITA shades: A1, A3, B2, TL (translucent), and OP (opaque).

• Easy to use
• Flexural strength: 99MPa
• Superior shading
• Radiopacity: 2.33 Al/mm
• 2 min working time, 5 min set time

INSTRUCTIONS

Crown & bridges, Inlay&onlay (Ceramic, Composite, porcelain) Cementation

    
1) Surface Treatment Of Restoration
  (1) Roughen The Bonding Surfaces of Indirect Composite. Porcelain And Metal Crowns With Diamond
  (2) Clean And Dry-thoroughly Clean All Internal Surfaces Of The Restoration With Water Spray And Air Dry
  (3) Silane Treatment -apply Silane Ceramic Primer To The Restoration Using Microbrush (For The Ceramic Restoration)
  (4) Apply Bond To The Restoration-apply A Double Coat Of Meta P&bond By Using Mircrobrush. Gently Air Dry For 5 Seconds, Light Cure For 10 Seconds.

2) Tooth Treatment
  (1) Apply 37% Meta Etchant Gel To Available Enamel / Dentin For 15 Seconds. Remove Gel And Rinse For 20 Seconds, Blot Dry Keep Moist, Do Not Rub.
  (2) Apply Bond To The Tooth-Apply A Double Coat Of Meta P&bond By Using Mircrobrush . Gently Air Dry For 5 Seconds . Light Cure For 10 Seconds

3) Apply Metacem
  (1) Directly Dispense Cement To The Entire Internal Surface Of The Restoration Using Mixing Tips Or Dispense Cement Paste Onto A Mixing Pad And Mix For 20 Seconds (Working Time : 2 Minutes).
  (2) Apply And Evenly Distribute A Thin Layer Of Cement To The Entire Internal Surface Of The Restoration.

4) Seat The Restoration-Seat The Restoration Slowly. Maintain Downward Pressure

5) Pre-cure-A 10-seconds Light Cure At The Margins Will " Gel" The Excess Cement For Easy Clean Up

6) Remove Excess Cement-Begin Clean Up Of Excess Cement Approximately 3-4 Minutes After Seating. Lift Off Excess Cement Around The Margins With An Explorer Or Small Scalper.

7) Light Cure -Once The Excess Cement Is Removed, Light Cure All Marginal Areas For 40 Seconds For Both The Buccal And Lingual Aspects Or Allowed To Self-cure For 10 Minutes For Start To Mix.

8) Finishing-Complete All Finishing And Polishing.

9) Instruct Patient To Avoid Applying Any Excessive Pressure For 15 Minutes

Composition
Base – Bis-GMA, DHEPT, borosilicate glass
Catalyst—Bis-GMA , TEGDMA, borosilicate glass

Included:
    2 Dual syringe (A3 & Translucent Shade, 9g/each)
    Bottle type adhesive 5mL
    20 Mixing Tips
    20 Etchant disposable tips
    Spatula
    Mixing pad paper
    10 Adhesive brush